piszczynski>Aleks |
piszczynski>Aleks |
||
| Line 49: | Line 49: | ||
*monitor session <number of session> source int g <port> | *monitor session <number of session> source int g <port> | ||
*monitor session <number of session> destination int g <port> | *monitor session <number of session> destination int g <port> | ||
Show IP Routes | |||
*show iproute | |||
Configure route | |||
*conf t | |||
*ip route <ipaddress of network> <subnet mask of network> <next hop - ipaddress of next router> | |||
Revision as of 18:37, 4 April 2019
Cisco Routers Commands
Show MAC address table
- show mac-address-table
Show VLAN Information
- show vlan brief
Put into config mode
- conf t
Create VLAN
- vlan <number>
- name <name>
- exit
Configure VLAN
- interface range Gig <port range>
- switchport mode access
- switchport access vlan <number>
- end
Show interfaces command - shows trunks
- show interfaces trunk
Configure Trunk
- interface gig <port>
- switchport trunk encapsulation dot1q
- switchport mode trunk
- end
Write command - write config to memory to keep changes after reboot
- wr
shutdown port
- conf t
- int
- g <port number>
- shutdown
Port mirroring
- monitor session <number of session> source int g <port>
- monitor session <number of session> destination int g <port>
Show IP Routes
- show iproute
Configure route
- conf t
- ip route <ipaddress of network> <subnet mask of network> <next hop - ipaddress of next router>